Making a Steel Knot Metal Handle - Industrial Style Handle - MIG Welding Project
In this video, I make a Steel Knot Metal Handle which is an Industrial Style Metal Handle, bending rebar to make the knot. I love the look of industrial furniture and all the decor that comes with it, and this rebar handle has the look I like. I hope you enjoy my video of the project, it was a lot of fun to make.
Main tools used, a MIG welder, angle grinder, drill, and a bench vise.
Always use all the correct safety gear, and use your tools safely, I am not a good role model for this.
The Rebar in the handle is 7mm, the wide flat bar is 50mm wide, 250mm long and 3mm thick, the smaller flat bar is 32mm wide, 207mm long and 6mm thick, the bolts are 25mm across the head and 50mm long, the shaft of the bolt is 16mm.
Hope you found something of use in my video or at least found it entertaining. Thank you.
The swivel “V” magnets, Amazon: amzn.to/3DCya4W
Milwaukee Inkzall Jobsite Fine Point Black Permanent Marker. Amazon: amzn.to/3kHrXfo
Milwaukee 4pk Inkzall Black Ultra Fine Point Pens. Amazon: amzn.to/2WKKpeE
MILWAUKEE 10” Locking Pliers, Curved Jaw, Amazon: amzn.to/3zzJH2u
-----Filming Equipment used in this video----
1)Camera - Canon EOS M6 Mirrorless Digital Camera with 15-45mm Lens. Amazon: amzn.to/3DIKnF4
2)Camera Tripod - Vanguard Alta Pro 2+ 263AB Tripod with Alta BH-100 Ball Head. Amazon: amzn.to/3yB8hP5
3)Camera Microphone - Rode Microphones VideoMicro Compact. Amazon: amzn.to/2WFmQVd
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark
Gavin Clark DIY
DISCLAIMER: This video and description contains affiliate links, which means that if you click on one of the product links, I’ll receive a small commission. This helps support the channel and allows me to continue to make more videos like this one. Thank you very much for your support!
Note: When you bend metal/rebar, you naturally weaken it. Bending it cold will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load.
Gavin Clark DIY
Жарияланды 5 ай бұрын